National Character Set; Power Reduction Commands / Select Number Of Copies - DCA Intertel 2000 Technical Manual

Comment:
n = 1 enables underlining
n = 0 disables underlining
All characters are printed underlined, including spaces.

4.2.19 NATIONAL CHARACTER SET

ESC 4
Format:
ASCII:
decimal:
hexadecimal:
Comment:
Characters following this command are printed in italics.
ESC 5
Format:
ASCII:
decimal:
hexadecimal:
Comment:
This command cancels italics printing selected by the ESC 4 command.
ESC R n
Format:
ASCII:
decimal:
hexadecimal:
Comment:
Parameter selects the national character set to be used, as shown in Chapter 8. This
command has priority over the hardware selection performed by DIP-switches SW1-4/
5/6.

4.2.20 POWER REDUCTION COMMANDS / select number of copies

ESC # s n
Format:
ASCII:
decimal:
hexadecimal:
Comment:
n = 0 disables the automatic standby mode.
n > 0 enables automatic standby mode, where "n" ranges from 1 to 25 and repre-
sents the time in seconds where the printer is inoperative before entering the standby
mode (default time = 20 seconds).
In the standby mode the current drain is reduced by half by disabling all the circuitry
not involved with receiving data from the computer.
DCA Intertel
Select italics printing
ESC 4
27 52
1B 34
Cancel italics printing
ESC 5
27 53
1B 35
Select national character set
ESC R
27 82
1B 52
Enable/disable automatic standby mode
ESC # s n
27 35 115 n
1B 23 73 n
36
n
n
n
DCA Intertel