Non-Fading Output - Kenwood KDC-X869 Instruction Manual

2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "AUD" is displayed above the
[2] button.
Refer to <Notes on Multi-function Key System> (page 8).
3
Enter Audio Control mode
Press the [2] ("AUD") button.
4
Select the Adjustment item section
Press the [NEXT] button.
Repeatedly press the button until the desired Adjustment item is
displayed above the [2] — [5] button.
1st section
Adjustment Item Button Display
Bass [2]
Middle [3]
Treble [4]
Balance & Fader [5]
2nd section
Adjustment Item Button Display
High Pass Filter [2]
Low Pass Filter* [3]
Loudness [4]
WOW [5]
3rd section
Adjustment Item Button Display
Volume offset [2]
Non-Fading* [3]
5
Select the Audio Control item for adjustment
Press the [2] — [5] button.
Each time the [2] — [5] button is pressed the adjustable audio
items are switched among ranges of all stage section's tables on
the following pages.
"BASS"
"MID"
"TRE"
"BL/F"
"HPF"
"LPF"
"LOUD"
"WOW"
"VOFF"
"N-F"
6
Adjust the Audio Control item
Press the [4] or [¢] button.
Each time the button is pressed the setting switches as shown
below.
7
Exit Audio Control mode
Press the [RTN] button.
• The loudness setting can also be adjusted by pressing the [4]
button.
• WOW can be set when SRS WOW or User memory is selected at
<System Q> (page 12).
*
• This mode is available only when <Non-fading Output> (page
12) is ON.
• The Loudness can not be set when SRS WOW is selected at
<System Q> (page 12).
— 13 —