Table of Contents
Advertisement
General features
Speaker & Woofer setting
Speaker setting allows the System Q settings to be fine-tuned
according to the type of speakers.
Woofer setting allows for Network configuration according to
the type of subwoofers.
1
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed when the standby mode is selected.
2
Press the Q button to enter the speaker setting mode.
3
Each time you press the FM/AM button, the mode switches as
follows:
Speaker setting mode
Woofer setting mode
4
•In speaker setting mode
Press either the 4 or ¢ button to select the type of
speaker. The setting switches as follows.
Off ( "Speaker Setting OFF" ) /
For 6/6x9 in. speaker ( "Speaker Setting 6
For 5/4 in. speaker ( "Speaker Setting 5/4 inch" )/
For the OEM speaker ( "Speaker Setting O.E.M.")
• In woofer setting mode
Press either the 4 or ¢ button to select the type of Sub
woofer. The setting switches as follows.
"Woofer OFF" / "12in type A" / "10in type A" / "12in type B" /
"10in type B" / "12in type C" / "10in type C" / "8inch" / "12in
type D" / "10in type D"
5
Press the Q button to end the speaker setting mode and
woofer setting mode.
NOTE
• Speaker setting function allows for tuning of bass, middle and
treble.
• Woofer setting allows for tuing of high-pass filter frequency,
low-pass filter frequency and non-fading level.
TEL Mute
Shut down the audio system temporarily whenever an
incoming call is received.
NOTE
TEL mute will not work if a wire is not connected to a car phone.
When the telephone rings:
When a call is received, "CALL" is displayed and all the unit
functions are temporarily interrupted.
Listening to Audio During a Phone Call:
Press the SRC (source) button.
"CALL" disappears from the display, and the volume of the
original source is restored gradually.
Turning TEL Mute Off After a Phone Call:
Hang up the phone.
"CALL" disappears from the display.
The original source (the one used before the phone call) is
returned to automatically, and the volume restored gradually.
Non-Fading Output
9/6 inch" ) /
*
You can turn the non-fading output on and off.
Turning non-fading output On/Off :
Press the NF button for at least one second to set the function
ON or OFF.
"NF ON" is displayed when the non-fading output is set ON.
— 14 —
Advertisement
Table of Contents
