Connecting Wires To Terminals - Kenwood KDC-W5031 Instruction Manual

Connecting Wires to Terminals

REMO. CONT
Rear left output (White)/
Rear right output (Red)
Fuse (10A)
8 6 4
7 5 3
8 6 4
7 5 3
28
|
English
To Steering remote
(KDC-W5031 only)
Wiring harness
(Accessory1)
TEL mute wire (Brown)
If no connections are made, do
not let the wire come out from
the tab.
Power control/ Motor
antenna control wire
(Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
See next page
A-–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
2
1
2
Connector B
1
Front left output (White) (KDC-W5031 only)
Front right output (Red) (KDC-W5031 only)
FM/AM antenna
input
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
To KENWOOD disc changer/ External optional accessory
(KDC-W5031 only)
To connect these leads, refer to
the relevant instruction manuals.
MUTE
P.CONT
ANT.CONT
Antenna Cord (ISO)
Connect to the terminal that
is grounded when either the
telephone rings or during
conversation.
To connect the KENWOOD
navigation system, consult
your navigation manual.
Connect either to the power
control terminal when using the
optional power amplifier, or to
the antenna control terminal in
the vehicle.