Plated Finish Maintenance; Glass Care - Cleaning - Ventus ME300 Installation And Operation Manual

Table of Contents

Advertisement

 
The  gasket  must  be  centred  on  the  edge  of  the  glass.  To  do  this  easily,  peel  back  a  section  of  the  paper 
covering the adhesive and place the gasket on a table with the adhesive side up. Stick the end of the gasket 
to  the  middle  of  one  edge,  then  press  the  edge  of  the  glass  down  onto  the  gasket,  taking  care  that  it  is 
perfectly centred on the gasket. Peel off more of the backing and rotate the glass and press the next section 
onto the gasket. Do not stretch the gasket as you place it. Do not apply the gasket on the center edge of the 
glass. Now pinch the gasket to the glass in a U shape, all around the glass. Reinstall the glass, being careful 
to centre the glass carefully in the door. Do not over‐tighten the screws. Note that the two main causes of 
broken door glass are uneven placement in the door and over‐tightening of retaining screws. 
Location 
Around each glass 
Both  glasses  used  in  the  ME300  are  5  mm  thick  of  dimension:  18"  x  15  5/16"      and  tested  to  reach 
temperatures  up  to  1,400  °F.    If  the  glass  breaks,  it  must  be  replaced  with  one  having  the  same 
specification. Contact your Ventis dealer to obtain a genuine replacement part (see "replacement parts", in 
appendix to get the proper part number). 
WARNING: 
DO NOT ABUSE THE GLASS DOOR BY SLAMMING IT AGAINST THE FIREPLACE. 
WARNING: 
DO NOT OPERATE THE FIREPLACE WITH A CRACKED OR BROKEN GLASS. 
WARNING: TEMPERED GLASS OR ORDINARY GLASS WILL NOT WITHSTAND THE HIGH TEMPERATURES OF 
THE ME300. 
7.7 Plated Finish Maintenance 
If your appliance has a plated finish, use a metal polish and a soft cloth to clean it. Do not  use abrasives 
such as steel wool, steel pads or an abrasive cleaner for they may scratch the finish. 
7.8 Glass Care – Cleaning 
To  clean  the  glass,  there  are  a  number  of  specially  designed  cleaners.  Your  authorized  Ventis  dealer  can 
recommend  a  suitable  cleaner  which  is  available  in  your  area.  Regular  household  glass  cleaners  will  not 
clean creosote and they usually contain ammonia that may stain the glass permanently.  
WARNING: 
ONLY WASH THE GLASS WHEN IT'S COLD. 
50 
Length 
48 5/8" (124 cm) 
 
 
Dimensions 
"U" shaped 
ME300 ‐ Installation and Operation Manual 

Advertisement

Table of Contents
loading

Table of Contents