Sony KP-57WV600 Operating Instructions Manual page 95

to reset TV to
factory settings
U Turn on the TV. While holding down the
RESE^I'button cm rrhe
remote
control, press the ~~~~~1~~ button on the TV. (1'he TV will turn itself off, Ihen
back on again.) Release the lG!SE I_ button.
Press the RESET' button on the remote control while in the Video Menu (see
page 72).
Press the RESET button on the remote control while in the Audio Memo (see
page Y4).
Re sure the Video k-&d opticxt is itot set to Skip (see page %I),
How to restore Video settings U
to factory settings
flow to restore Audio
Q
settings to factory settings
Cannot cycle through the
F-1
other video equipment
connected to the TV
Cannot operate Menu
L-8
t..ost password
1-3
LJ
If a menu option appears in gray, this indicates that tlic TV is in a staC-r in
which the menu option is not available.
In the password screen (see page SO), enter I-he following masiei' password:
4357. The master password clears
your
previous password; it crtnnoi he
used to temlxxarily unblock channels.
The STAND BY LED (see pge 14) blinks when the TV is turned on, then
shuts off when the picture is displayed. If the LED blinks continuously, this
may indicate the TV needs service.
Thd TIMER LED (see page 14) indicates that the timer is set. When the
timer is set, this LED will remain lit even when the TV is
tumecl off.