Connecting Wires To Terminals - Kenwood KDC-MP5029V Instruction Manual

Connecting Wires to Terminals

Video output (Yellow)
To the monitor unit
Connection cable (Accessory9)
To parking brake detection
switch harness of car
For the sake of safety, be
sure to connect the parking
sensor.
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal
of the motor antenna, or to the power
terminal for the booster amplifier of the
film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To front right speaker
Car fuse box
(Main fuse)
24
|
English
Parking sensor
wire (Green)
Fuse (10A)
To front left speaker
To rear left speaker
To rear right speaker
Ignition key switch
–
+
Battery
To connect these leads, refer to
the relevant instruction manuals.
To KENWOOD disc changer/
External optional accessory
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Car fuse box
ACC
Front right output (Red)
Front left output (White)
Rear left output (White)
L
Rear right output (Red)
R
FM/AM antenna input
Wiring harness
(Accessory1)
FRONT • L
FRONT • R
REAR • L
REAR • R
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)