Table of Contents
Advertisement
Installation
non-Japanese cars
Metal mounting strap
(commercially available)
Firewall or metal support
Bend the tabs of the mounting
sleeve with a screwdriver or similar
utensil and attach it in place.
Self-tapping screw
(commercially available)
Screw (M4X8)
(commercially available)
• Make sure that the unit is installed securely in place. If
the unit is unstable, it may malfunction (for example, the
sound may skip).
Japanese cars
1
Refer to the section <Removing the hard rubber
frame> (page 27) and then remove the hard
rubber frame.
2
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and
secure the unit with the accessory screws.
T
N
8 mm
MAX.
3
ø5mm
Accessory3...for Nissan car
Accessory4 ...for Toyota car
N
T/N
T
T: Toyota cars
N: Nissan cars
8mm
MAX.
4
ø5mm
• During installation, do not use any screws except for
those provided. The use of different screws might result
in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used
with excessive force during the installations.
Using the Relay Connector
1
Plug the vehicle's harness into the relay
connector.
2
Plug the parking brake detection wire into the
relay connector.
Vehicle harness
1
3
Lock the cable clamp.
Cable clamp
4
Press down using pliers until the conductive
metal is even with the plastic surface.
5
Lock the lid.
Lid
Relay connector
Accessory0
2
Detection wire
3
5
4
Conductive metal
English
25
|
Hide quick links:
Advertisement
Table of Contents
