Download Print this page

TeachLogic Maxim II User Manual page 25

Infrared sound field system
Hide thumbs Also See for Maxim II:

Advertisement

Troub
le Shooting
• System is turned "on" but
o Verify AC power; the Red LED lights when
turned "on"
o System has power but no sound
• When using the microphone, the voice is
and/or signal drop out occurs
Check the charge on your batteries
o
• When
microphone, the voice is intermittent and/or has a
static like sound
o Try moving the
plug-in connector or where it is connected to
the microphone
Check if system has been unplug
Check circuit breaker
Call maintenance for assistance
Verify charged batteries in body-pack
Turn "on" bod
signal
presence
volume control)
Check the Green LED in the center of
the dome sensor
If sensor LED is not lit, the dom
has either been disconnected or
power for the sensor has failed
If LED is lit but there is no sound
If
either condition cannot be resolved,
call TeachLogic customer service.
Recycle the batteries by placing th
transmitter in the charger and press the
black button and hold for 3-5 seconds
The yellow LED will light and the charger
will automatically dis
and then recharge to full charge. (Time
required 4
-6 hours)
Recheck the system after cycling the
batteries
If the problem persists, replace the
batteries
using
th
e
body-pack
cable back and forth at the
there is no sound
y-pack and check for
(Green
LED
charge the batteries
transmitter
ged
below
e sensor
the
distorted
e
and

Advertisement

loading