Advertisement
Fi
nal Connection of the System
W
ith all the two speaker wires and sensor cable neatly routed
to the amplifier, we are ready to complete the installation.
• Connecting the Dome Sensor
• Plug the sensor cable into either of th
jacks (RCA)
• Coil up the excess cable (if applicable) and place it
out of the way and view
• Connect the auxiliary audio sources
• The auxiliary input jacks are dual RCA phono jacks.
They are labeled on the back corresponding to the
volume control on the front panel. Connect each
source using a shielded cable with RCA connector
• You can use stereo c
will be summed internally so both channels
passed through as a combined monaural signal.
Connecting the Speakers
• Cut the speaker wires to the proper length.
• Split the cable and strip approximately ⅜ - ½" off
each wire.
• Twist the stranded wire and if you have a soldering
iron available, it is a good practice to tin the wire
ends.
• It is important to observe speaker polarity (note
speaker diagram on back panel of Maxi
• Unplug the phoenix block connector an
RED wire to either outside screw terminal. Insert
other wire into the next slot. Tighten the setscrew.
• Do same with the other speaker cable.
ables because the two channels
e sensor input
s.
will be
m II).
d insert the
Advertisement
