Advertisement
Co
ngratulations, this completes the installation and i
no
w time to show the user how to use the system
• Turn "on" the Maxim II via the po
• Plug a microphone into the body-pack and set the
gain control at zero (max. CCW)
• Turn the body-pack transmitter "on" via slide
switch on the side of the transmitt
• Observe the Green LED on the body-pack indicating
a useable charge on the batteries
• Observe th
control, it indicates a signal being received from the
body-pac
• Turn Ch. A volume to approximately mid scale (12
o'clock)
• While talking i
gain control CW until you've achieved a comfortable
listening level
• Using the Handheld microphone, turn it "on", the
Green LED will light and the Red LED a
the Ch. B control will light indicating signal
presence from the handheld micro
• Slowly turn the Ch. B volume control CW until the
desired listening level is achieved
• Now venture around the room while alter
talking
interruption or drop outs while moving about
• Connect an auxiliary audio source (computer, Video
projector, DVD player
cable with appropriate connectors, plugged into the
designated RCA jack
• Turn the audio source "on" a
operation. Adjust the volume level of each auxiliary
input to the desired listening level.
• Computers and remote control projectors often have
very low output. If more volume is req
the respective input sensitivity control on back
panel. Adjust to desired volume level.
• Once all the auxiliary inputs have been verified and
adjusted, the system is ready for full operation
e Red LED near the Ch. A volume
k
nto the microphone, slowly turn the
into
each
, VCR, ipod) using a shielded
wer switch
er
phone
microphone.
nd engage its
t is
djacent to
nately
Observe
no
uired, adjust
Advertisement
