Ikdc-Bt838U; Audio Adjustments; Audio Control; Audio Setup - Kenwood KDC-BT838U Instruction Manual

Audio Adjustments
Audio Control
You can adjust following Audio Control items;
AdjpM.l~.1 QIII.It)~I,IIRift9l!~t"11~;it:i~j~.11il
Rear volume "REAR VOLUME" 0- 35
- - - - - - - -
Subwoofer level "SUB-W LEVEl:' -15 -
+
15
------"-----------
System
Q
"USER"I"ROCK"I User setting/Rock/Pops/Easyl
"POPS"I"EASY"
1
Top
401
JaulNatural
"TOP4G" !"JAZZ"1
"NATURAL"
- - - - -
Basslevel* "BASS LEVEl:' -8 - +8
----=------=------
Middle level* "MIDDLE LEVEl:' -8 - +8
- - - - - - - -
Treble level* "TREBLE LEVEL' -8 - +8
- - - - - - - -
Balance "BALANCE" Left 15 - Right 15
Fader "FADER" Rear 15 - Front 15
Exit Audio (ontrol mode (Volume control mode)
* Source tone memory: Puts the set up value in the
memory per source.
b\
~
• "USER": The ranges selected lastly for Bass level, Middle
level, and Treble level are recalled automatically.
1
Select the source to adjust
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Enter Audio Control mode
Press the [AUD] knob.
3
Select the Audio item to adjust
Press the [AUD] knob.
4
Adjust the Audio item
Turn the [AUD] knob.
S
Exit Audio Control mode
Press any button.
Press a button other than the [AUD] knob or
[~]
and [AD] button.
20
I
KDC -BT838U
Audio Setup
You can set Sound system
I
such as follows;
Rear High Pass Filter "HPF-R"
Low Pass Filter "LPF"
Subwoofer Phase "SW PHASE"
Volume offset "VOL-OFFSET"
- - - - -
Loudness "LOUD"
-=-D-uaC-: 1 Z' - on-e--:C-Sy-ste-m- "2 ZONE"
b\
~
• Volume offset: Sets each source's volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones during
low volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by "Zone2" of
<Function Control> (page 6).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [AUD] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 20) or [.a.]/[T] button on the remote control
(page 30).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
2
Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [AUD] knob.
4
Adjust the Audio setup item
Turn the [AUD] knob.
S
Exit Audio Setup mode
Press the [AUD] knob for at least
1
second.