Connections - NEC i-Series Gateway Quick Installation Manual

&RQQHFWLRQV
The i-Series Gateway requires connections A through E as shown below.
Front of Unit
Back of Unit
B
100-240 V ~ 0.8A
Table 2. PBXtender Connections
Letter Label
A Console
B -
C Telephony
Interface
D WAN1
E LAN
i-Series Gateway 
A
C onsol e
W AN
PW R 1 2 3 R eset
C
50-60 HZ
TELEPHONY INTERFACE
Cable Type
DB-9 Connect to a PC for administration in two ways:
‰Ã
‰Ã
Note: Set the COM port as follows; Baud rate: 9600,
Databits: 8, Parity: none, Stopbits: 1,
Software flow control: XON/XOFF
Power Connect to a 120VAC outlet.
Connect as the last step. (See page 8.)
RJ 21 Wire to a punchdown block and then to the PBX.
(See Table 3, page 7.)
DB 25, serial, Used for a synchronous or asynchronous-serial
straight-through connection. Connect to a TA, CSU/DSU, or other
network device.
Note: An RS-530 type cable or DB-25 to M34 cable
should be used for high-speed links to V.35 equipment.
RJ 45 Ethernet Used for Telnet management or for connecting the unit
to the LAN for use in Voice over IP (RVP_IP)
applications.
Page 6
Por t St at us
1 2 3 4 5 6 7 8 9 10 11 12
D
WAN 1
WAN 2
0
Description
Direct serial connection to a PC.
Connect to a modem for remote access.
(See page 14 for modem installation and setup.)
LN K
C LN
E
XMT LNK
RCV CLN
G-6000G-SKE, Rev AA