Installation Environments; (Rvp_Direct); Asynchronous -Serial - NEC i-Series Gateway Quick Installation Manual

Installation Environments

Introduction This section of the guide provides the necessary information to configure the i-Series
Gateway using the MI. The units are programmed at the factory with "default" settings
providing basic parameters to accommodate most network environments.
Before beginning the configuration process, it is necessary to identify the type of
Which type network device connected to the i-Series Gateway. Once you know the connection type,
of Network use Table 4, below, to find the appropriate configuration checklist.
Device do
you have?
Table 4. Network devices
To configure the
A Synchronous-Serial device – V.35,
RS-232, RS-530 via WAN Port

(RVP_Direct)

An Asynchronous -serial device via WAN
Port(s) 1 or 2
(RVP_Direct) using RS-232 Protocol.
An IP* device – via Ethernet port
(RVP_IP)
* IP-based products from NEC America,
Inc. utilize Voice over IP (VoIP) technology
to deliver remote voice solutions. The voice
quality of these solutions is dependent on
variables such as available bandwidth,
network latency and Quality of Service (QoS)
initiatives, all of which are controlled by the
network and Internet Service Providers.
Because these variables are not in NEC
America, Inc. control, it cannot guarantee
the performance of the user's IP-based
remote voice solution.
i-Series Gateway 
i-Series
Gateway with .....
Page 10
See page.....
11
12
13
G-6000G-SKE, Rev AA