Isdn Requirements (For Asynchronous Connections) - NEC i-Series Gateway Quick Installation Manual

‰Ã
Consult the supported TA list for the most commonly used devices.
TAs (for Async)
TAs (for Sync 128k bonding)
CSU/DSUs
Note: In order for the Async-RS 232 Dial feature to work properly for these devices, you need to setup
each device to accept incoming "AT Commands". Consult the documentation provided with each device
for proper instructions.
‰Ã
Proper wiring with adequate punch down blocks to connect the Gateway to the PBX. Must be wired
according to Table 3, page 7, and provide RJ-21 female connector.

ISDN Requirements (for Asynchronous connections)

Before you install your units, you need to order an ISDN line at both the local site and the remote branch
office. This ISDN line should be capable of the following:
‰Ã
The ability to make two "data" calls using both B Channel of the ISDN line.
‰Ã
If Long Distance, both "data" calls need to be routed as a "data" call.
Note: Confirm this with your Long Distance provider when you order your ISDN Line.
i-Series Gateway 
MFG
(See note.)
•
Motorola
Bitsurfr Pro
•
Bitsurfr Pro EZ
• ISU 128 (See note.)
Adtran
• ISU 2X64
• Express 3000
• Express 3001
• Express NTU
• ISDN TA
3Com
•
Motorola
Bitsurfr Pro
• ISU 128 (See note.)
Adtran
• ISU 2X64
• Acculink 3160,
Paradyne
3164, 3165
• 7110 SNMP
• TSU LT, TSU100,
Adtran
120, 600
• DeskTop 554A
General
DataComm
• FCD-1L
RAD
• DataSmart Max
ADC Kentrox
72761, 78640
• FT100S
Motorola
• 56/T1
Larscom Orion
Page 3
Model(s)
G-6000G-SKE, Rev AA