NEC i-Series Gateway Quick Installation Manual page 21

Installing the modem at the i-Series Gateway Site
Procedure
1. Connect the analog telephone line to the modem.
2. Plug the modem cable (provided with the unit) into the back of the modem.
3. Power-up the modem. The modem runs a series of self-diagnostic tests.
4. Plug the other end of the modem cable into the port labeled "Console port" on the front of the i-Series
Gateway.
5. Power-up the i-Series Gateway unit. The modem status LED for "Data Terminal Ready" should be
RED indicating the modem is ready to receive data.
Note: Refer to the Modem User's Guide for specific LED information.
i-Series Gateway 
Page 21 G-6000G-SKE, Rev AA