Setup Wizard - NEC i-Series Gateway Quick Installation Manual

Setup Wizard

The i-Series Gateway provides a console setup wizard that guides a user through most of the required
programming/configuration required to complete initial setup of the units, via the VT100 management
console accessed through the DB-9 management port. You can use the MI to set parameters not
configurable through the wizard.
Access the setup wizard through the console MI, requiring a PC to connect to the unit (i-Series Gateway)
via the DB-9 console port. The wizard queries the user on the basics of the particular configuration, and
uses this information to establish the initial configuration programming.
Standard Console UI vs. the Setup Wizard
When a unit is first powered up, it checks a Setup Wizard flag. If the flag is set, the standard console UI is
displayed. If the flag is not set, the system asks you to run the Setup Wizard. After this initial prompt the
Setup Wizard flag is set. This prevents the unit from asking you to run the Wizard again. You can also
access the Setup Wizard through the console MI if you want to run it later.
How to access the Setup Wizard through the MI
Path: Gateway->Utilities -> Setup Wizard
i-Series Gateway 
Page 15 G-6000G-SKE, Rev AA