Rough-In Dimensions; Foreword - State Water Heaters Ultra Forcce SUF 60 120 Installation & Operation Manual

GAS VALVE PIPING
SUF-120 1/2" NPT
SUF-150,
199 & 250 3/4" NPT
Table 1. RECOVERY CAPACITIES - NATURAL GAS / L.P.
Input
Model BTU/Hr.
SUF 60 120NE 125,000 Nat.
SUF 60 120PE 120,000 L.P.
SUF 100 150NE 150,000 Nat.
SUF 100 150PE 150,000 L.P.
SUF 100 199NE 199,000 Nat.
SUF 100 199PE 199,000 L.P.
SUF 100 240NE 240,000 Nat.
Input
Model Kwh
SUF 60 120NE 37
SUF 60 120PE 35
SUF 100 150NE 44
SUF 100 150PE 44
SUF 100 199NE 59
SUF 100 199PE 59
SUF 100 240NE 70
Recovery capacities are based on heater performance at 94% thermal efficiency.
These designs comply with the current edition of the American National
Standard for Gas Water Heaters, Volume III, ANSI Z21.10.3 / CSA 4.3 as
an automatic circulating tank water heater, and automatic storage water
heaters.
Detailed installation diagrams are found in this manual. These diagrams
will serve to provide the installer with a reference for the materials and
methods of piping necessary. It is highly essential that all water, gas
piping and wiring be installed as shown on the diagrams.
Particular attention should be given to the installation of thermometers at
the locations indicated on the diagrams as these are necessary for
checking the proper functioning of the heater.
ROUGH-IN-DIMENSIONS
Approx.
TEMPERATURE RISE - DEGREES °F - GALLONS PER HOUR
Gallon
Capacity 30 40 50
60 475 356 285
60 456 342 274
100 570 427 342
100 570 427 342
100 759 569 456
100 759 569 456
100 912 684 547
Approx.
Liter
Capacity 17°C 22°C 28°C
227 1798 1348 1079
227 1726 1295 1037
379 2158 1616 1295
379 2158 1616 1295
379 2873 2154 1726
379 2873 2154 1726
379 3452 2589 2071

FOREWORD

60 70 80
237 203 178
228 195 171
285 244 214
285 244 214
380 325 285
380 325 285
456 391 342
TEMPERATURE RISE - DEGREES °C - LITERS PER HOUR
33°C 39°C 44°C
898 768 674
863 738 647
1079 924 810
1079 924 810
1438 1230 1079
1438 1230 1079
1726 1480 1295
In addition to these instructions, the equipment shall be installed in
accordance with those installation regulations in force in the local area
where the installation is to be made. These shall be carefully followed in all
cases. Authorities having jurisdiction should be consulted before installations
are made.
In the absence of local codes, the installation must comply with the latest
editions of the National Fuel Gas Code, ANSI Z223.1/NFPA 54 and the National
Electric Code, NFPA 70 . The former is available from the CSA International,
8501 East Pleasant Valley Road, Cleveland, OH 44131, and both documents
are available from the National Fire Protection Association, 1 Batterymarch
Park, Quincy, MA 02269.
2
90 100 110 120
158 142 129 119
152 137 124 114
190 171 155 142
190 171 155 142
253 228 207 190
253 228 207 190
304 274 248 228
50°C 56°C 61°C 67°C
598 538 488 450
575 519 469 432
719 647 587 538
719 647 587 538
958 863 784 719
958 863 784 719
1151 1037 939 863
130 140
110 102
105 98
132 122
132 122
175 163
175 163
210 195
72°C 78°C
416 386
397 371
500 462
500 462
662 617
662 617
795 738