Safety; Transit Screws; General; Child Lock On Start/Stop Button - Whirlpool PROW 0612IIM Installation And Maintenance Manual

SAFETY

TRANSIT SCREWS

Before the machine can be used the three trans-
it screws must be removed. See chapter "Mecha-
nical Installation".

GENERAL

• Read and keep this manual!
• Any electrical work or plumbing must be car-
ried out by qualified tradesmen.
• The machine is not designed to be used by
persons (even children) that are physically or
mentally handicapped or lack experience and
knowledge. Such persons must receive instruc-
tion in how to use the machine from the person
responible for their safety.
• Children must be watched to ensure they do
not play with the machine.
CHILD LOCK ON
Start/Stop
To prevent accidental button pushes on the
button you can activate the child lock
Start/Stop
function. The
Start/Stop
in for three seconds to activate the machine.

DOOR

The door is opened electrically, so it cannot be
opened until the machine is connected to the
electrical supply! The door can however be ope-
ned in an emergency, see Troubleshooting.
SAFETY
BUTTON
button then must be held

OVERFILL CUT-OUT

If the water level in the machine rises above
normal the overfill cut-out shuts off the water
intake and starts pumping out the water. The
programme resumes when the water level has
dropped.

PACKAGING

Recycle the packaging according to recommen-
dations in your area.

TRANSPORT/WINTER STORAGE

If you intend to transport the machine or store
it over winter in unheated premises, empty the
trap and the drain pump, see the chapter on
Maintenance.
Any questions? Call service.

SCRAPPING

At the end of its life the machine must be disa-
bled before being scrapped.
Contact your local recycling centre to find
out where to dispose of it or recycle it.
The machine has been built and marked to
facilitate recycling.
WASHING MACHINE
3