Assembly And Setup; Setting Up The Ip Camera - Siemens CCIS1337-LP Configuration Manual

Assembly and setup

8 Assembly and setup
8.1

Setting up the IP camera

22
Siemens Building Technologies
Fire Safety & Security Products
Mount the lens on the IP camera.
1.
Connect a monitor to the video output (
2.
Danger of burns from the housing of the IP camera
The housing of the IP camera becomes hot during operation.
WARNING
Do not touch the housing of the IP camera.
Danger of overheating for the IP camera
During operation of the IP camera, there is a danger that the unit will overheat.
This affects the service life of the unit.
CAUTION
1. Ensure that there is sufficient air circulation for cooling.
2. Do not operate the IP camera in its protective housing.
Connect the power supply.
3.
IP camera with separate power supply
Connect the power supply to the power supply connection (7).
–
IP camera with network connection (
Ensure that the network equipment (such as the switch/hub/router) supports
–
Power Over Ethernet (POE).
Ensure that the polarity is correct for DC power supply.
CAUTION
Connection errors can cause malfunctions and/or damage to the IP camera.
In order to reduce the electromagnetic radiation sufficiently, wrap the cable
4.
once around the core (see Fig. 2).
Cable
Power supply cable
Y/C cable
Fig. 4 Connecting the cable
Set the focal length.
5.
) using a BNC cable.
9
)
10
Illustration
EIM-0050751G
IP Camera
LP
LP/MP
04.2006