Service Configuration - Siemens CCIS1337-LP Configuration Manual

10.5.7 Service configuration

Siemens Building Technologies
Fire Safety & Security Products
Open the unit's home page. See Section 7.4 Accessing the unit's home page.
1.
In the Configuration menu, select the menu option Camera and the Service
2.
suboption.
The Service dialog will appear:
Fig. 13 Service
Enter the desired settings in this dialog.
3.
Blemish
Factory defaults
Back focus
IMPORTANT
Cover the lens before using the pixel error compensation (blemish)
function.
Failing to do so may cause errors with the IP camera.
If the lens is covered a test can be made for defective pixels.
Click the Detect button.
The presence of defective pixels will be checked and corresponding
compensation configured.
CAUTION
The factory defaults function will reset the IP camera to its
configuration on delivery.
Click the Restore button.
The following confirmation message will be displayed:
Are you sure you want to restore the factory settings of the IP
camera?
The following options for flange focal length (back focus) are available:
ON
The lens aperture is opened completely and the shutter speed set
temporarily to AUTO to facilitate configuration.
OFF
The function is deactivated.
Configuration
43
04.2006