Siemens CCIS1337-LP Configuration Manual page 55

Siemens Building Technologies
Fire Safety & Security Products
The service mode is indicated by a periodic blinking of the LED at the network
connection. As soon as the LED blinks at a rate of about once per second, the
unit is in service mode for 60 seconds.
Reconnect the network cable to the device.
7.
Click the OK button or press the Enter key to execute the prepared command
8.
line in the Command Prompt window.
See point 3 in this regard.
Check the IP address using the ping command (e.g. ping 192.168.1.100).
9.
Successful assignment of the IP address setting is indicated when the ping
command shows that data packages are returning to the client PC.
An IP address allocated in this way will only remain valid until the next time
the device is restarted.
10. For this reason, you should now re-assign a permanent IP address to the
device via the device homepage. See Section 10.3.1 Changing the device IP
address via the device home page.
The permanent IP address will be applied only after the IP camera is
restarted. See Section 10.3.1 Changing the device IP address via the device
home page.
Maintenance
55
04.2006