Wiring - Harbor Breeze 317058 User Manual

WIRING

1C. FAN AND LIGHT CONTROLLED BY TWO
WALL SWITCHES: If you intend to control the
fan and light with separate wall switches,
connect BLACK wire from fan to BLACK wire
from the independent wall switch for the fan.
Connect BLUE wire from fan to the BLACK
wire from the other independent wall switch for
the light. Connect WHITE wire from fan to
WHITE wire from ceiling. Connect all GROUND
(GREEN) wires together from fan (on motor
assembly (D) and mounting bracket (B)) to
BARE/GREEN wire from ceiling. (Fig. 1C)
NOTE: Black wire is hot power for fan. Blue wire
is hot power for light kit. White wire is common
for fan and light kit. Green or bare wire is ground.
2.
Wrap electrical tape (not included) around each
individual wire connector (CC) down to the wire as
shown in Fig. 2.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of box
from the black and blue (if applicable) connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (CC) into outlet box.
Hardware Used
CC E3 Wire Connector
3.
IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will cause a
loud humming noise from fan. To reduce the risk
of fire or electrical shock, do NOT use a full range
dimmer switch to control fan speed. (Fig. 3)
x4
10
FAN AND LIGHT CONTROLLED BY TWO WALL
SWITCHES
1C
BLACK (WALL SWITCH)
BLACK (WALL SWITCH FOR LIGHT)
120 V Power
FROM WHITE
CEILING
GROUND/GREEN (BARE)
GREEN
BLUE
BLACK
FAN
GREEN
FROM FAN
2
CC
3
Dimmer
Switch
For illustrative purposes only--not
intended to cover all types of controls
WHITE
WHITE
CC
CC
CC
3
2
1
Speed
Switch