Technical Specifications; Operation; Getting Started - Proceq Pundit PL-200PE Operating Instructions Manual

2.

technical Specifications

Pundit PL-200
Range
Resolution
Display
Pulse Voltage UPV
UPE
Bandwidth
Receiver Gain
Memory
Regional Settings Metric and imperial units and multi-language
Battery
Battery Lifetime
Operating 0°C – 30°C (Charging, running instrument)
Temperature 0°C – 40°C (Charging, instrument is off)
Humidity
IP Classification
Pulse Echo Range
Transducer
Frequency
Aperture Size
6
Pundit PL-200PE
0.1 – 7930 μs
0.1 μs (< 793 μs), 1 μs (> 793 μs)
7" colour display 800x480 pixels
100 – 450 Vpp
– 100 – 400 Vpp
20 – 500 kHz
1x – 10'000x (0 – 80dB) [11 steps]
Internal 8 GB Flash memory
supported
Lithium Polymer, 3.6 V, 14.0 Ah
> 8h (in standard operating mode)
-10°C – 50°C (Non-charging)
< 95 % RH, non condensing
IP54
0.1 – 1200 μs
50 kHz
2x25 cm
3.

Operation

The information provided in this manual covers the Pulse Echo application
only. The Pundit PL-200PE also supports all functionality provided by the
Pundit PL-200. It is necessary to purchase the BNC adapter cable (Part
No. 327 01 049) for operation with standard P-wave transducers. A full
listing of the standard transducers can be found on the Proceq website.
The Pundit PL-200 operating manual is provided on the product DVD.
3.1

Getting Started

Battery installation
To install the Battery (B) into the Pundit Touchscreen (A), lift the stand as
shown. Insert the battery and fasten in place with the screw.
There are three status LEDs 1 (see page page 3). The middle LED is
red while charging and turns to green when fully charged. The other LEDs
are application specific.
NOTE! Only use the battery charger provided.
2
© 2014 Proceq SA