Proceq Pundit PL-200PE Operating Instructions Manual page 10

6 Settings:
Enter the settings menu.
7
Stop/Save (Right Button on transducer):
Stop the current measurement.
Save the current measurement.
Save the current series and continue the measurement.
8
Start/Snapshot (Left Button on transducer):
Begin the measurement.
Save the current measurement as displayed on the
screen and continue measuring.
L
10
R
9
Cursor Selection
Automatic triggering.
Manual triggering. Set the cursor position manually, by
dragging it to the left or right. The trigger position may
also be adjusted later on the saved waveform in the
Explorer or in PL-Link.
Available in transmission time mode only. Allows a
marker to be set on a second echo and the difference
between thet two echos is displayed.
Manually adjust the colour intensity.
10 Automatic Estimation of Pulse Velocity
This setting is available in the Distance and B-Scan
modes. The pulse velocity may be entered manu-
ally after having made a control measurement on an
object of known thickness. Alternatively, it is possible
to estimate the pulse velocity directly on surface of the
test object. Tap on this button and press the transducer
against the surface to make a measurement. A number
of measurements can be made and an average value
is calculated. Tap
ting. Pulse velocity may be subsequently adjusted on
saved files in the Explorer or in PL-Link.
NOTE! Typical shear wave pulse velocities for concrete are in
the region 2000 - 2500 m/s
to apply the pulse velocity set-
© 2014 Proceq SA