Warranty - Sanremo Milano LX SAP Instruction Booklet

ENGLISH
the user must check that this is not due to:
- power failure or blackout
- lack of mains water supply or no water inside the boiler.
For any other causes, contact a qualified SANREMO After-Sales Service Centre.
BEFORE CARRYING OUT ANY WORK INSIDE THE APPLIANCE OR REMOVING ANY
PART OF THE HOUSING, ALWAYS DISCONNECT FROM THE ELECTRICITY SUPPLY.
Every purchased appliance (keep the receipt, invoice and delivery note) is covered by a statutory
guarantee. This warranty envisages the replacement free of charge of parts that are shown to the
service centre or manufacturer's satisfaction to be defective due to faulty materials or workmanship
and providing that the appliance has not been misused or tampered with by unauthorised persons
or persons using incorrect components or techniques.
Any defective part shall be returned to the manufacturer.
The appliance must not be cleaned using a water jet.
Do not put the appliance in water.
The appliance must not be positioned near to any source of heat.
The appliance is unsuitable for outdoor installation.
To ensure safe use the appliance must be in a level position.
If the power cable is damaged, have it replaced by a SANREMO After-Sales Service
Centre, since a special tool is required for this purpose.
The appliance must be used in rooms with a temperature between 5°C and 35°C.
IN THE EVENT OF FAILURE OR MALFUNCTION, REQUEST SERVICE ONLY FROM
QUALIFIED PERSONNEL AT THE AFTER-SALES SERVICE CENTRE.
The data and features indicated in this booklet are not binding on the manufacturer, which reserves
the right to make changes to its models at any time.
The manufacturer shall not be under any liability for injury to persons or damage to property arising
from failure to comply with the instructions given in this booklet.
The volumetric dispensing by microprocessor is a technologically highly sophisticated system
that allows many programmable functions and extreme reliability to be obtained while keeping
dimensions to a minimum.
A single control unit controls both the water level in the boiler and the various coffee quantities. The
electronic system comprises:
- power pack with high insulation transformer resistant to short circuit in compliance with the
standards UL940VO, VDE 0551 and EEC 15;
- boiler water level control through maximum level sensor;
- data transmission;
- programmable pushbutton panel with four coffee quantities, a button for programming or continual
dispensing and a programmable button for the dispensing of hot water;
- relays in compliance with the standard VDE 0551, UL940VO and with 4kW insulation;
- printed circuits in FR4 to UL940VO.
APPLIANCE FAILURE

WARRANTY

WARNINGS
MICROPROCESSOR DISPENSING
20