Sirius Plug And Play Satellite Radio; Cb Radio Power Wiring - Winnebago Journey User Manual

Dash Radio Sound through Home
Theater Speakers
–If Equipped
• Press the Speaker
selector switch on the
dash to RADIO
position to connect
the radio to the theater
sound speakers.
Volume is adjusted
with radio buttons or
radio remote..
• When the Ignition switch (key) is Off, the
Radio Power switch must be in HOUSE
position.
• While driving, the Radio Power switch should
be in ENGINE position.
NOTE:The Aux. Battery Disconnect switch must
also be on while listening to the radio
because the audio relay is powered by
house batteries. If the Aux Batt. switch is
off, the speakers will not emit any sound.
SIRIUS PLUG AND PLAY
®
SATELLITE RADIO
–If Equipped
(Located inside the driver or passenger
side overhead compartment)
Take Sirius Plug and Play on the go - in your
RV, at home, the office, other vehicles, or
anywhere else! It is featured with universal
docking capability so you can easily move Sirius
to different locations and enjoy your favorite
programming (separate docking station
included).
DRIVING YOUR MOTOR HOME
To install the satellite unit, place your Sirius
radio into the docking station, aligning the tabs at
the edges of the the radio adapter with the
grooves in your radio. Gently push the radio
down until it is fully seated in the docking station.
For complete operating instructions, see the
owners manual of your headunit.
When your Sirius radio is connected via the
SiriusConnect Docking Kit to your headunit, the
buttons and controls of the Sirius radio will be
disabled, and a SiriusConnect message or logo
will be displayed.
To remove the satellite unit from the docking
station, press the release button while pulling the
radio out of the docking station. You can now
take your Sirius Plug and Play and install it in
your car with the supplied car kit.
Further Information
See the Sirius user guide provided in your
InfoCase for complete operating and installation
instructions.

CB RADIO POWER WIRING

Your coach is pre-wired for CB radio power
connection. The wires are located beneath the
dash to the left of the steering wheel.
Look for a pair of wires - yellow (+) and white
(-) with connectors and flag labels suspended
from the wiring harness.
SECTION 3 –
3-15