Operation Of Wireless Remote Control; Sleep Button; Fan Button; Clock Button - DeLonghi 9K Owner's Manual

Operation of wireless remote control

Note: Be sure that there are no obstructions between receiver and remote controller;
Don't drop or throw the remote control; don't let any liquid in the remote control and
put the remote control directly under the sunlight or any place where is very hot.
Signal transmitter
Remote control
ON/OFF button
¡ñ
¡ñ
Press this button, the unit will be turned on,
press it once more, the unit will be turned
off. When turning on or turning off the unit,
the Timer, Sleep function will be canceled,
but the presetting time is still remained.
MODE
MODE button
Press this button, Auto, Cool,Dry, Fan,
Heat mode can be selected circularly.
Auto mode is default while power on.
Under Auto mode,the temperature will not
be displayed; Under Heat mode, the
initial value is 28¡æ
modes, the initial value is 25¡æ
AUTO
COOL
DRY
FAN
HEAT
(Only for cooling and heating unit.)
Name and function of wireless remote control
o F)
;Under other
( 82
o
77 F)
(
SLEEP

SLEEP button

¡ñ Press this button, Sleep On and Sleep
Off can be selected. After powered on,
Sleep
turned off, the Sleep function is canceled.
After Sleep function set up, the signal of
Sleep will display. In this mode, the time of
timer can be adjusted. Under Fan and Auto
modes, this function is not available.
FAN

FAN button

¡ñ Press this button, Auto, Low, Middle, High
speed can be circularly selected. After
powered on,Auto fan speed is default.
Under Dehumidify mode, Low fan speed
only can be set up.
¡ñ
CLOCK

CLOCK button

Press this button, the clock can be set up,
signal
seconds, the value can be adjusted by
pressing + or - button, if continuously
press this button for 2 seconds above,
in every 0.5 seconds, the value on ten place
of Minute will be increased 1. During blinking,
repress the Clock button, signal
constantly displayed and it denotes
the setting succeeded. After powered on,
12:00 is defaulted to display and signal
¡ñ
time value is Clock value, otherwise is Timer
value.
TEMP
.
TEMP button
Press this button, can set up temperature:
presetting temperature (to display room),
indoor ambient temperature (to display
indoor temperature), outdoor ambient
temperature (to display outdoor temperature),
and that will go around. It is defaulted that
there is no signal displaying. Remark:when
operating this button,the wireless remote
control displays the presetting temperature
all along.
Off is defaulted. After the unit is
Middle fan
Low fan
High fan
blink and display.Within 5
will be displayed. If there is signal
be displayed that denotes the current
will be