Combination Brake And Park Brake Pedal; Run - Tow/Maintenance/Storage Switch; Fig. 7 Accelerator And Brake Controls - Ezgo 2010 TXT 48 FLEET Owner's Manual

Read all of manual to become familiar with this vehicle. Pay attention to all NOTICES, CAUTIONS, WARNINGS and DANGERS.

Fig. 7 Accelerator and Brake Controls

If key switch is 'ON' and park brake is set, depressing the
accelerator inadvertently will release the park brake and
will cause the vehicle to move which could cause severe
injury or death.
Depressing the accelerator pedal will release the park
brake if it is engaged. This is a feature to assure the vehi-
cle is not driven with the park brake engaged. Depressing
the accelerator pedal is not the preferred method of
releasing the park brake.
NOTICE
Depressing the lower section of the brake pedal is the pre-
ferred method of releasing the park brake to assure the long-
est service life of brake components.
COMBINATION BRAKE AND PARK BRAKE
PEDAL
The brake pedal incorporates a park brake feature (Ref.
Fig. 7). To engage, push down on the upper section of the
pedal until it locks in place. The park brake will release
when the service brake pedal is depressed. Use the lower
section of the brake pedal to operate the service brake
system.
RUN - TOW/MAINTENANCE/STORAGE
SWITCH
To reduce the possibilty of severe injury or
death resulting from loss of vehicle control, con-
sider the grade of the terrain the vehicle is on
and set vehicle's park brake accordingly before
switching the Run - Tow/Maintenanc/Storage
switch to the 'Tow/Maintenance/Storage ' posi-
tion. When in the 'Tow/Maintenance/Storage '
position, the Anti-Roll Back and Walk-Away
OPERATION AND SERVICE INFORMATION
Park
Service
Brake
Brake
Accelerator
safety features of the system no longer function.
Before attempting to tow vehicle, move the Run-Tow/
Maintenance/Storage switch to the 'Tow/Maintenance/
Storage' position. Failure to do so will damage the con-
troller or motor.
Before disconnecting or connecting a battery, or any oth-
er wiring, move the Run-Tow/Maintenance/Storage
switch to the 'Tow/Maintenance/Storage' position.
After connecting a battery, or any other wiring, wait a min-
imum of 30 seconds before moving the Run-Tow/Mainte-
nance/Storage switch to the 'Run' position.
The vehicle is equipped with a two position switch locat-
ed under the passenger side of the seat on the controller
environmental cover (Ref. Fig. 8).
Fig. 8 Run-Tow Maintenance/Storage Switch
With the switch in 'TOW/MAINTENANCE/STORAGE'
position:
• the controller is deactivated
• the electronic braking system is deactivated
which allows the vehicle to be towed or roll freely
• the warning beeper is deactivated
With the switch in 'RUN' position:
Owner's Guide
RUN TOW
MAINTENANCE
STORAGE
TOWING - Always select
'TOW MAINTENANCE'
position before towing
DO NOT alter or tamper with this unit. Unauthorized
modifications can result in SERIOUS INJURY or damage
to the vehicle and will void the warranty.
To disable electrical system, turn key switch to 'OFF' and
remove battery wires.
ALWAYS turn key to 'OFF' before
disconnecting or reconnecting battery wires.
ELECTRICAL ARC or BATTERY EXPLOSION
can occur if key is not in the 'OFF' position.
WAIT 30 seconds after reconnecting batteries BEFORE
turning key switch to 'REVERSE', 'FORWARD' or
'NEUTRAL' positions.
Controller
Environmental
Cover
B
B
613048
Page 5