Controls And Indicators; Key/State Of Charge Meter; State Of Charge Meter; Direction Selector - Ezgo 2010 TXT 48 FLEET Owner's Manual

OPERATION AND SERVICE INFORMATION
Read all of manual to become familiar with this vehicle. Pay attention to all NOTICES, CAUTIONS, WARNINGS and DANGERS.
B
tions recommended by the battery manufacturer.
2. Make sure the charger connections to the battery ter-
minals are tight and clean. Check for any deforma-
tions or cracks in the plastic parts. Check the charger
harness for chaffing and rubbing. Inspect all wiring for
fraying, loose terminals, chaffing, corrosion or deterio-
ration of the insulation.
3. Keep the cooling fins free of dirt and debris, do not ex-
pose the charger to oil, dirt, mud or to direct heavy wa-
ter spray when cleaning equipment.
4. Inspect the plug of the battery charger and the vehicle
receptacle housing for dirt or debris. Clean the DC
connector monthly or more often if needed.
If vehicle is to be charged with a non E-Z-GO charger, refer to
the instructions supplied with the charger.

CONTROLS AND INDICATORS

Vehicle controls and indicators consist of:
•

direction selector

•

state of charge meter

•

accelerator pedal

• combination service and park brake pedal
• run - tow/maintenance/storage switch
KEY/ STATE OF CHARGE METER
Located on the dash panel, this switch enables the basic
electrical system of the vehicle to be turned on and off by
turning the key. To prevent inadvertent operation of the
vehicle when left unattended, the key should be turned to
the 'OFF' position and removed (Ref. Fig. 5).
Key
Fig. 5 Key & State of Charge Meter
Page 4
NOTICE
Direction Selector
State of Charge Meter
STATE OF CHARGE METER
Located in the dash, the state of charge meter indicates
the amount of usable power in the batteries (Ref. Fig. 5)
DIRECTION SELECTOR
To prevent loss of control, do not move vehicle
direction selector while the vehicle is in
motion.Moving the selector will result in sud-
den slowing of the vehicle and the beeping of
a warning device.
To reduce the possibilty of component damage,the
vehicle must be completely stopped before moving the
direction selector.
If the direction selector is shifted before the vehicle
comes to complete stop, a warning beeper will activate.
Located on the dash panel, this switch permits the selec-
tion of either 'F' (forward), 'R' (reverse) or neutral (the
position between forward and reverse). Vehicle should be
left in neutral when unattended (Ref. Fig. 6).
ACCELERATOR PEDAL
Unintentional movement of the accelerator
pedal will release the park brake and may
cause the vehicle to move which could result
in severe injury or death.
With the key switch 'ON', depressing the accelerator
pedal starts the motor. When the pedal is released, the
motor will stop (Ref. Fig. 7). To stop the vehicle
more quickly, depress the service brake.
Owner's Guide
FWD
REV
Forward
Reverse
Neutral, as shown
Fig. 6 Direction Selector