Virtual Com Port Driver Installation Windows 98 Se - GridConnect NET232 User Manual

Configure
10. Select "Include this location in the search".
11. Press Browse to locate the "C:\SiLabs\MCU\CP2101\WIN" directory. Once this directory is
selected press OK.
12. Verify that the correct path and filename are shown and press Next.
13. Press Finish to finish installing the "CP2101 USB to UART Bridge Controller".

3.3.4 Virtual COM Port Driver Installation Windows 98 SE

Follow these steps to install the Windows 98 VCOM driver:
1. Connect the USB cable between the host computer and the NETUSB target device.
2. Windows will open a "Found New Hardware Wizard" window. Press Next to continue.
3. Select "Search for the best driver for your device (Recommended)" and press Next.
4. Select "Specify a location".
5. Press Browse to locate the "C:\SiLabs\MCU\CP2101\WIN" directory. Once this directory is
selected press Next.
6. Verify that the correct path and filename are shown and press Next.
7. Press Finish to finish installing the "CP2101 USB Composite Device".
8. Windows will open a second "Found New Hardware Wizard" window. Press Next to continue.
9. Select "Search for the best driver for your device (Recommended)" and press Next.
10. Select "Specify a location".
11. Press Browse to locate the "C:\SiLabs\MCU\CP2101\WIN" directory. Once this directory is
selected press Next.
12. Verify that the correct path and filename are shown and press Next.
13. Press Finish to finish installing the "CP2101 USB to UART Bridge Controller".
3-4 NET232/NETUSB User Guide