Changing A Water Filter Cartridge - Whirlpool Refrigerator Instructions For Use Manual

CHANGING A WATER FILTER CARTRIDGE

1. Locate the water filter cartridge cap below the freezer
compartment door. Rotate the cap counterclockwise to a vertical
position and pull the cap and filter cartridge out through the base
grille.
Note: Since there is water in the cartridge, some spilling may
occur.
2. Remove the cartridge cap by sliding it off the end of the old
cartridge. DO NOT DISCARD THE CAP .
3. Take the new cartridge out of its packaging and remove the
protective cover from the o-rings.
4. Slide the cartridge cap onto the new cartridge as shown.
5. With cartridge cap in the vertical position, push the new filter
cartridge into the base grille until it stops. Rotate the cartridge cap
clockwise to a horizontal position.
6. RUN WATER THROUGH THE DISPENSER UNTIL THE
WATER RUNS CLEAR (about 9-14 litres or 6-7 minutes). This will
clean the system and clear air from the lines.
Note: as air is cleared from the system, water may spurt out of
the dispenser.
Ordering replacement filters
To order more water filter cartridges, please contact your after-
sales service.
16
1
2
3
4
5