Whirlpool Refrigerator Instructions For Use Manual page 9

USING THE APPLIANCE
GUIDE TO SELECTING FUNCTIONS
Stand-by
This function turns off the refrigerator and freezer compartments. To activate the standby function, press
the button for 3 seconds: both displays will go off and a dash will appear on the left display. To reset the
function, carry out the same procedure until the previously set temperatures are displayed.
Note: Remember that this operation does not disconnect the appliance from the power supply.
Freezer temperature
The factory-set ideal temperature is -18°C. As soon as the freezer compartment reaches the required
temperature, it is automatically displayed.
To change the temperature, press the
Refrigerator temperature
The factory-set ideal temperature is +5°C.
To change the temperature, press the
displayed.
Ice On/Off
To switch the ice maker on press the on-off button until one of the two icons comes on
To deactivate the function, repeat the procedure until both icons go off.
Ice mode
This function enables to select the type of ice desired: crushed ice
information refer to the section "Using the ice and water dispenser" section.
Ice and water dispenser light
The light can be switched on and off by pressing the
the two dispenser levers; the light will switch off automatically once the water or ice has been dispensed.
buttons until the display shows the required value.
buttons until reaching the required value that it will be
button on the control panel or pressing one of
or ice cubes . For further
.
11