Dx System Configuration; Terminology - YOKOGAWA DX2004T User Manual

DX System Configuration

Communication Interface User's Manual
EtherNet/IP Communication Interface User's Manual
PROFIBUS-DP Communication Interface User's Manual
Ethernet
Temperature
controller
Measurement
Pulse input*
Transmitter power supply*
Page 75
Alarm output*
Sec 3.5-3.8
FAIL/status output*
*: Option

Terminology

IM 04L45B02-02EN
The DX can be used to configure a system as shown below.
Referenced sections are of the DX2000 User's Manual.
Referenced pages are of this manual.
Recorder
input
Sec. 3.3
Sec. 3.10
Sec. 2.9
• Memory sample
The operation of recording measured data.
• Memory start
The operation of starting memory sampling.
• Memory stop
The operation of stopping memory sampling.
• Display data
The waveform data shown on the DX display. The data recorded at the sampling
interval for the displayed data.
• Event data
Measured data recorded at a sampling interval separate from that of the display data.
Serial
communication*
RS-232, RS-422/485, or PROFIBUS-DP*
DX2000T
USB port*
Keys
Introduction to Functions
PLC (programmable
logic controller)
PC
EtherNet/IP
PC
CF card
Page 24
USB flash memory
Sec. 2.12
Keyboard
Sec. 2.11
Barcode reader
Sec. 2.11
Remote input*
Sec. 7.1
Monitor*
Page 76
PLC
9