Turning The Power On/Off; Turning The Power On; Turning The Power Off - YOKOGAWA DX2004T User Manual

Turning the Power ON/OFF

Turning the Power ON

Turning the Power OFF

IM 04L45B02-02EN
Before turning ON the power switch, check that
• The power cord/wires are connected correctly to the DX.
• The DX is connected to the correct power supply (see page 78).
If the input wires are connected in parallel with other devices, do not turn ON/OFF
the power switch of the DX or another device during operation. This can have
adverse effects on the measured values.
1.
Open the operation cover.
2.
Turn ON the power switch.
After performing a self-test for a few seconds, the operation screen appears.
3.
Close the operation cover.
• If nothing is displayed when the power switch is turned ON, turn OFF the
power switch and check the points listed above one more time. After checking
the points, turn ON the power switch again. If the DX still does not work, it is
probably a malfunction. Contact your nearest YOKOGAWA dealer for repairs.
• If an error message is displayed on the screen, take measures according to the
description in chapter 11, "Troubleshooting" in the DX2000 User's Manual.
• Turn ON the power switch, let the DX warm up for at least 30 minutes, and then
start the measurements.
Before turning OFF the power switch, check that the external storage medium is
not being accessed.
1.
Open the operation cover.
2.
Turn OFF the power switch.
3.
Close the operation cover.
CAUTION
CAUTION
CAUTION
13