Inspect Shipment; Safety Guides - EcoWater ETF AIV-10 Owner's Manual

Ecowater systems air aspirated iron filter
Hide thumbs Also See for ETF AIV-10:
Table of Contents

Advertisement

ECOWATER
S Y S T E M S
The parts required to assemble and install the Air
Aspirated Iron Filter are included with the unit.
Thoroughly check the water filter for possible shipping
damage and parts loss. Also inspect and note any
damage to the shipping carton.
Follow the installation instructions carefully. Failure to
install the filter properly voids the warranty.
Before you begin installation, read this entire manual.
Then obtain all the materials and tools you will need
to make the installation.
Check local plumbing and electrical codes. The
installation must conform to them.
Use only lead-free solder and flux for all sweat-sol-
der connections as required by state and federal
codes.
Use care when handling the filter. Do not turn upside
down, drop, or set on sharp protrusions.
Do not locate the filter where freezing temperatures
occur. Do not attempt to filter water over 120°F.
Freezing, or hot water damage voids the warranty.
Avoid installing in direct sunlight. Excessive sun heat
may cause distortion or other damage to non-metallic
parts.
The filter requires a minimum water flow of 5 gallons
per minute at the inlet for backwash.
Inspect Shipment & Safety Guides

INSPECT SHIPMENT

Remove and discard (or recycle) all packing materials.
To avoid loss of small parts, we suggest you keep the
small parts in the parts bag until you are ready to use
them.

SAFETY GUIDES

Recommended maximum allowable inlet water
pressure is 80 psi. Use a pressure reducing valve if
necessary. Be sure the addition of a pressure reduc-
ing valve will not reduce the flow to less than the 5
gallons per minute needed for backwash.
This filter controller works on 24 Volt, 60 Hz electri-
cal power only. Be sure to use the included trans-
former, and plug it into a nominal 120V, 60 Hz house-
hold outlet that is in a dry location only, grounded
and properly protected by an over-current device
such as circuit breaker or fuse.
This system is not intended to be used for treating
water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after
the system.
4
European Directive 2002/96/EC requires all
electrical and electronic equipment to be
disposed of according to Waste Electrical
and Electronic Equipment (WEEE) require-
ments. This directive or similar laws are in
place nationally and can vary from region to
region. Please refer to your state and local
laws for proper disposal of this equipment.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ETF AIV-10 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Etf aiv-12Etf eiv-10

Table of Contents