Status Led/Buzzer Indications; Changing Remote Control Pin Code - Security Perth Agility 3 User Manual

Status LED/Buzzer Indications

After each transmission (indicated by a flashing Green LED) from the remote control, the
Agility sends a status response indicated by the remote control's LEDs and Buzzer:
LED Indications
Operation
Away Arm
Stay Arm
Disarm
Alarm
*If the 1st LED changes to orange it indicates a low battery condition.
Buzzer Indications
Sound
1 beep
3 beeps
5 beeps

Changing Remote Control PIN Code

Each remote control can be defined by your installer to be activated with a unique PIN
code.
To change the remote control PIN code (from the remote control itself):
Note: To change the PIN code it is mandatory to perform the following procedure in close
proximity to the control panel.
4\?
Press the +
Enter the remote control current 4 digit PIN code.
Press followed by a new 4 digit code.
Press .
The panel will send a confirmation message. The remote control will sound a long beep
and the Green LED will turn on. If no confirmation sound is heard the old PIN code will
remain. Repeat the procedure again to replace to a new code.
1st LED *
(Send
command)
Green
Green
Green
Green
Status
Confirmation
Error
Alarm
simultaneously for 2 seconds.
Agility 3 User Manual
Code
2nd LED
(Receive
Status)
Red
Orange
Green
Flash Red LED
Page 42