Disarming Your System; System Disarming - Security Perth Agility 3 User Manual

Agility 3 User Manual

2.2 Disarming your system

Disarming your system causes the detectors not to trigger an alarm when violated. When
you enter the premises, the Entry Delay begins to count down. You must disarm the
system within the Entry Delay time to prevent the system from triggering an alarm. The
disarming operation will be followed by a local message announcement (if defined).
Note: If an alarm occurred in the system, it is recommended to leave the premises. Only
after police investigation should you consider that the burglar is no longer on
your premises and you can re-enter. In special cases (if programmed by your
installer) arming the system after an alarm might require a technician code. For
more information refer to your installer
Your Agility offers the following kinds of disarming:

System disarming:

Disarming deactivates the partitions assigned to the specified user code
To disarm using Procedure for Disarming
Quick mode: . All partitions assigned to the button will be
disarmed
High security mode:
Press followed by code or proximity tag.

Press the button. All partitions assigned to the button will be
disarmed.
Send SMS: [Code][D], example 1234D
Page 15
> Code