Advertisement
2.1.3 Removing the front panel assembly
(See Fig.6~9)
• Prior to performing the following procedure, remove the metal
cover and the DVD mechanism assembly.
(1) Disconnect the card wire from connector CN705 on the mi-
crocomputer board in the center of the right side of the
body.
(2) Disconnect the card wire from connector CN301,and the
wires from connector CN300 and CN710 on the main
board in the center of the left side of the body.
(3) Disconnect the card wire from connector CN704, and the
wire from CN703 on the microcomputer board.
ATTENTION:
When disconnecting the wires from CN703 and CN710,
remove the spacer attaching the wires.
(4) Disconnect the card wire from connector CN442 on the FL
connection board on top of the body.
(5) Remove the screw D on each side of the body.
(6) Remove the two screws E on the bottom of the body.
(7) Release the joint a on the bottom and the two joints b on
the right and left sides of the body using a screwdriver. Re-
move the front panel assembly toward the front.
Front panel assembly
D
Micro computer board
b
CN705
Fig.6
Main board
CN710
CN301
CN300
CN703
Fig.7
FL connection board
CN442
CN710
Fig.8
E
a
Fig.9
UX-A7DVD
Front panel assembly
Spacer
D
Micro computer board
b
CN704
Spacer
D
CN704
CN703
Front panel assembly
(No.22013)1-7
Advertisement
