Advertisement
2.3.3 Removing the servo control board
(See Fig.4)
CAUTION:
Solder the sorting round point before disconnecting the flexible
wire extending from the pickup. If you do not follow this instruc-
tion, the pickup may be damaged.
(1) Solder the sorting round point on the flexible wire connect-
ed to connector CN101 on the servo control board.
(2) Disconnect the flexible wire from connector CN101 on the
servo control board.
(3) Disconnect the card wires from connector CN201 and
CN202 on the servo control board. Release the two joints
d.
(4) Move the servo control board in the direction of the arrow
to release the joint e, and remove upward.
CAUTION:
Unsolder the sorting round point after reassembling.
2.3.4 Removing the traverse mechanism assembly
(See Fig.5, 6)
• Prior to performing the following procedure, remove the
clamper assembly, the tray and the servo control board.
(1) Remove the four screws B attaching the traverse mecha-
nism assembly.
CAUTION:
When reassembling, get the flexible wire extending from the
spindle motor board through the slot f of the elevator.
CN201
d
e
CN101
Servo control board
Fig.4
B
Traverse mechanism
assembly
B
Fig.5
B
Traverse mechanism
assembly
Fig.6
UX-A7DVD
Sorting round point
CN101
Flexible wire
d
CN202
B
B
B
f
(No.22013)1-23
Advertisement
