Advertisement
UX-A7DVD
2.4.3 Removing the pickup
(See Fig.17~19)
• Prior to performing the following procedure, remove the feed
motor assembly.
(1) Remove the screw l, the T spring(S) and the shaft holder
with the plate.
ATTENTION:
When reassembling, reattach the T spring (s) correctly to
press the shaft
(2) Detach the part n of the shaft upward and move the part o
in the direction of the arrow, then remove the shaft from the
spindle base.
(3) Release the joint p in the direction of the arrow.
(4) Pull out the shaft from the pickup.
(5) Remove the two screws J attaching the actuator.
(6) Release the joint of the actuator and the lead spring, and
pull out the lead spring.
ATTENTION:
When reattaching the pickup, attach the spring under the
shaft (See fig.19)
1-28 (No.22013)
Pickup
p
I
Plate
n
T spring(S)
Fig.17
J
Actuator
Lead spring
Pickup
Shaft
Fig.18
Fig.19
Spindle base
o
Shaft holder
Actuator
Lead spring
Pickup
Shaft
Spring
Advertisement
