Advertisement
UX-A7DVD
2.1.10 Removing the base chassis / microcomputer board
(See Fig.23~25)
• Prior to performing the following procedure, remove the metal
cover, the DVD mechanism assembly, the front panel assem-
bly, the rear cover/ rear panel, the main board and the DVD re-
lay board.
(1) Disconnect the wires from connector CN701 and CN711
on the microcomputer board in the center of the right side
of the body.
(2) Remove the screw R attaching the voltage selector board.
(3) Remove the two screws S attaching the base chassis on
top of the body.
(4) Remove the two screws T attaching the microcomputer
board and release the two joints f .
Base chassis
Microcomputer board
CN701
1-12 (No.22013)
CN711
Voltage selector board
Fig.23
R
Fan bracket
Microcomputer
board
Base chassis
S
Fig.24
T
f
Fig.25
Advertisement
