Advertisement
2.1.5 Removing the tuner pack
(See Fig.15)
• Prior to performing the following procedure, remove the metal
cover.
(1) Disconnect the card wire from connector CN1 on the tuner
pack on the right side of the body.
(2) Remove the two screws I on the back of the body.
2.1.6 Removing the fan
(See Fig.16,17)
• Prior to performing the following procedure, remove the metal
cover, the DVD mechanism assembly, the rear cover/rear pan-
el and the DVD relay board.
(1) Disconnect the wire from connector CN711 on the micro-
computer board on the right side of the body.
(2) Remove the three screws J attaching the fan bracket on
top of the body and release the joint d.
(3) Remove the two screws K attaching the fan.
Tuner pack
CN1
Fig.15
Micro computer board
CN711
J
Fan bracket
Fig.16
Fan bracket
Fan
Fig.17
UX-A7DVD
I
J
d
J
K
(No.22013)1-9
Advertisement
