Table of Contents
Advertisement
SY-P4I845GV/PEISA Plus Quick Start Guide
23. Sometimes the system finds my CD-ROM, and sometimes not
1.
Ensure the CD-ROM is working properly.
2.
The power supply may not provide enough power for all installed
devices. Remove all redundant devices, such a second hard
drive/CD/DVD-ROM/RW, and reboot. If the system functions
normally after the removal some power-consuming devices, there may
be a need for a reduction in installed devices or for a more powerful
power supply.
24. When I boot up my newly installed system, the monitor reads
"Floppy Boot Failure" and the LED of the floppy disk does not go
out.
1.
Ensure the red wire of floppy ribbon cable goes to Pin1 on the floppy
drive side (don't trust the "key lock" or "notch") and use the
end-connector of the cable (don't use middle one).
2.
Some floppy drivers have their own jumper to make the same twist as
the twist on the cable. Ensure this jumper is set correctly.
43
Advertisement
Table of Contents
