Table of Contents
Advertisement
SOYO SY-P4I845GV/PE Plus Quick Start Guide
9.
Replace the graphic card. Check the specs of the graphic card to see if
it is compatible with the motherboard.
3. The system powers up without screen display, but beeping sound is
heard.
1.
Ensure the monitor cable is secured to the graphic card or onboard
VGA port.
2.
Short JP5 to clear the CMOS and check all jumper settings on the
motherboard.
3.
Ensure memory modules and graphic card are properly inserted in
respective slots.
4.
Replace the memory modules and restart the system again.
5.
Replace the graphic card and restart the system again.
4. The system turns on for a few seconds and then shuts down by itself.
1.
Ensure the CPU fan is connected to the CPUFAN1 connector and is
turning during the operation.
2.
Ensure that the 20-pin and 4-pin power connectors are connected.
3.
The CPU might be overheating. Check the CPU fan to see if it is
defective or if the CPU heatsink has contact with the CPU.
4.
Clear the CMOS by shorting Pin 2-3 of JP5.
5.
Make sure your power supply is capable of handling system workloads.
6.
Sometimes adding a more powerful power supply to the system will be
helpful. The minimum requirement for a qualified power supply is
350W. The actual power requirement is subject to the total power
consumption of all components installed.
5. During Power Up Self Test (POST) routines, the system halts and
displays "Verify DMI pool data... " What should I do?
1.
Clear the CMOS by shorting Pin 2-3 of JP5 and reboot.
2.
Disconnect ALL IDE cables (HDD,CDROM)
3.
If problem goes away please check IDE configuration, and attach just
one IDE device at a time to determine which IDE device or IDE cable is
corrupted.
4.
If the problem still exists, remove all the add-on cards except the
graphic card and reboot. If everything goes well, insert the removed
add-on cards one by one to find out which one of them goes wrong.
38
Advertisement
Table of Contents
