Table of Contents
Advertisement
Kickback,
Blade Contact.
Fingers,hand
or arm
can be cut off.
Follow instructions
for ripping.
Fig. !59 Kickback,
Blade Contact
Safety Sign
13. Turn the saw off
_
WARNING:
Blade continues
to turn
for about
12 seconds
after power
is
turned
off.
Do not reach for cut
workpiece
until blade stops.
Fingers
or
hand can be cut off by the turning
blade.
Wait for blade to stop turning.
14. Remove
yellow key from red switch.
Bevel Ripping
To make a bevel rip cut:
1. Set the saw in the desired
position.
2. Index the arm to 0° and lock in position.
3. Bevel the blade to the desired
angle.
4. Follow
steps for making
a rip cut.
Note: For dadoing,
molding
and edging,
fol-
low instructions
for crosscutting.
Dadoing
1. Instructions
for using dado blades are
provided
with the dado blade.
2. The saw arbor
is designed
for a dado set
up to 13/16 inches wide.
Use of a wider dado
on the arbor could cause the dado and arbor
nut to spin off. Take several
passes of the
dado if cut required
is greater
than 13/16 of
an inch wide.
3. To avoid excessive
load on the motor
never cut a 13/16 inch wide dado deeper
than
1/8 inch in one pass.
4. When installing
the dado on the arbor, al-
ways install the inside loose collar first to en-
sure good arbor
nut engagement.
Make sure
the arbor nut is snug.
Install
the arbor
nut
directly
against
the outside
of the dado.
Molding
!. Instructions
for using the molding
head are
provided
with the molding
head.
2. Use of molding
head or drum sander
with
the saw arbor vertical
requires
an opening
(next to rear face of fence)
for saw arbor
clearance.
See Cutting
Accessories
section
to
make a molding
fence.
Edging
1. Edging
requires
the use of a dado or mold-
ing head in the horizontal
position
(parallel
to table).
2. Use proper accessory guard when edging.
See Recommended
Accessories section.
_'k
A
_LWARNINL_:
Using the saw without the
proper
accessory
guard for edging
is ex-
tremely
dangerous.
Hands,
fingers
or
arm can be cut off. Buy, use and follow
instructions
for edging
guard.
3. Use an auxiliary
fence when edging with
the radial arm in the 0° miter
position.
See
Cutting
Accessories
section
to make auxiliary
fence for edging
in the 0 ° miter position.
72
Advertisement
Table of Contents
