Cable Routing For Riser Card (2U Node) - Dell PowerEdge C6220 II Owner's Manual

6 Install the expansion card. See "Installing the Expansion Card for 2U
Node" on page 191.
7 Replace the system-board assembly. See "Installing a System-Board
Assembly" on page 171.

Cable Routing for Riser Card (2U Node)

1 Connect the USB cable to the 2U riser card, and connect the other end
of the cable to the corresponding connectors on the system board. See
Figure 3-49.
Figure 3-49. Cable Routing for 2U Riser Card USB Cable
Item Cable
USB cable
From
(Riser Card)
USB connector
Removing and Installing System Components | 221
To
(System Board)
internal USB
connector