System Configuration Jumper Settings On The C6220 System Board341 - Dell PowerEdge C6220 II Owner's Manual

System Configuration Jumper Settings on the C6220 System Board
The function of system configuration jumper installed on each C6220
system board is shown below:
Figure 5-19. System Configuration Jumpers on the C6220 System Board
Table 5-2. System Configuration Jumper on the C6220 System Board
Jumper Function
Service Mode
NVRAM Clear
BIOS Recovery
ME Firmware Recovery
MEDBG1
Power Button Pass
Jumper Function
PWRD_EN
NOTE: The * in the table of system configuration jumper describes the default
status and the default state is not active state.
Off
*Disable
*Disable
*Disable
*Disable
*Disable
*Disable
Pin1-2
*Enable
Jumpers and Connectors | 341
On
Enable
Enable
Enable
Enable
Enable
Enable
Pin2-3
Disable