Removing A 2.5-Inch Hard-Drive Blank; Installing A 2.5-Inch Hard-Drive Blank - Dell PowerEdge C6220 II Owner's Manual

Removing a 2.5-inch Hard-Drive Blank

CAUTION: To maintain proper system cooling, all empty hard-drive bays must
have drive blanks installed.
NOTE: This section is applicable to systems with hot-swappable hard drives only.
1 Pull the handle to remove the 2.5-inch hard-drive blank out of the
hard-drive bay. See Figure 3-7.
Figure 3-7. Removing or Installing a 2.5-inch Hard-Drive Blank
1 2.5-inch hard-drive blank
3 latch

Installing a 2.5-inch Hard-Drive Blank

1 With the latch facing up, slide the latch into the hard-drive bay first.
2 Push the 2.5-inch hard-drive with a slight inclination into the hard-
drive bay until the hard-drive blank is seated in place. See Figure 3-7.
2 handle
Removing and Installing System Components | 159