Dell PowerEdge C6220 II Owner's Manual page 121

Token Setup option
Load Optimal
00D8
Defaults
Legacy USB
00FE
Support
Legacy USB
00FF
Support
0117 SATA Port0
0118 SATA Port0
0119 SATA Port1
011A SATA Port1
011B SATA Port2
011C SATA Port2
011D SATA Port3
011E SATA Port3
011F SATA Port4
0120 SATA Port4
0121 SATA Port5
0122 SATA Port5
Embedded
0135
SATA Controller
Embedded
0137
SATA Controller
Embedded
0138
SATA Controller
Description
Requests a optimal default of SETUP values on the next
boot.
System does not provide legacy USB support for operating
system.
System provides legacy USB support for operating system.
Sets the 1st Serial ATA drive controller to OFF.
Sets the 1st Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
Sets the 2nd Serial ATA drive controller to OFF.
Sets the 2nd Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
Sets the 3rd Serial ATA drive controller to OFF.
Sets the 3rd Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
Sets the 4th Serial ATA drive controller to OFF.
Sets the 4th Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
Sets the 5th Serial ATA drive controller to OFF.
Sets the 5th Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
Sets the 6th Serial ATA drive controller to OFF.
Sets the 6th Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
Disables the SATA controller. The token applies to the
first on-board SATA controller.
Enables the SATA controller. Sets the device class code as
IDE and uses PCI IRQ (referred as Native mode). This
token applies to the first on-board SATA controller.
Enables the SATA controller. Sets the device class code as
SATA and sets up the AHCI BARs and registers. This
token applies to the first on-board SATA controller.
Using the System Setup Program | 121